top of page

Spring Steel Belt clip with screws and adhesive patch. Will work on most RFHero remotes. Use the adhesive patch to attach belt clip to your remote without modification, or drill four holes using a #43 drill bit to use included screws.

 

HOW TO ATTACH USING SCREWS:

Partially disassemble remote prior to drilling holes by removing enclosure screws and separating the backshell. Failure to do so will likely result in damage to internal components when drilling. Damage caused in this way will void the standard warranty. Hold clip in position where you wish for it to be attached, and mark the positions you wish to drill holes using a pemanent marker or similar. Drill holes using #43 or similarly sized drill bit. Reposition belt clip, then drive screws in using a phillips head screwdriver until snug. Do not use an electric drill, as this may strip the holes while driving the screws.

 

HOW TO ATTACH USING ADHESIVE PATCH:

To attach the adhesive patch, use rubbing alcohol to wipe down both surfaces where the patch will be place. Allow to dry, then peel away one side of the patch, press in place centered on the belt clip and rub it with some force to ensure adhesion. Afterward, remove the cover from the other side of the patch, then position the clip where desired and do the same as above. Allow to fully set for some time (24 hours is optimum) prior to use, or adhesive may not fully adhere to both surfaces.

 

USING BOTH THE ADHESIVE PATCH AND SCREWS:

Simply follow the same steps as above, starting with the adhesive patch step. However, do not remove the belt clip after marking holes to drill as it may damage the adhesive patch. Instead, carefully drill through the holes on the belt clip, then drive the included four screws by hand as normal.

Spring Steel Belt Clip

$12.99Price
    bottom of page